0 votes
82 views
in Off-Topic by (9.4k points)

Going to make some 7/64” pin punches for removing locating pins in out vise jaws. The actual 7/64” part needs to be about 2.5-3” long so I was going to make the handle/body if the punch out of 3/8 or 1/2” 1018 and lock the drill rod in with a set screw so it can be replaced when it breaks. I want S7 to try to make them a little more shock resistant. McMaster has S7 but not in 7/64”. Theoretically I could buy 1/8” and turn it, but that requires tooling and work holding I don’t have and don’t want to buy for this project.

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.
...