0 votes
20 views
in cnc programming by (9.0k points)

In this article, we describe how to use G73 pattern repeating cycle in CNC lathe machines with all details and examples.

G73 Cycle Introduction

G73 cycle is used pattern repeating cycle on CNC Lathe machines.

G73 Cycle Format

G73 UΔI WΔk Rd ;
G73 Pns Qnf UΔu WΔw Ff ;

Parameters

ΔI = Machining stock on “X” axis / machining allowance on “X” axis.
ΔK = Machining stock on “Z” axis.
d = Number of rough cuts.
ns = Sequence number of the first block of the program which specifies the finish figure.
nf = Sequence number of the last block of the program which specifies the finish figure.
Δu = Finish allowance on “X” axis / diameter.
ΔW = Finish allowance on “Z” axis / face.
f = Feed

 


Need to more?

In this article, we described How to use G73 pattern repeating cycle in CNC lathe machines with all details and examples. For more details;

For your comments, suggestions and questions, you can write to us from the “Comments Section” below without registration and please consider to share this post!

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.
...