0 votes
609 views
in cnc programming by (9.0k points)

In this article, we describe how to use G84 cycle for front tapping in CNC lathe machines with all details and examples.

G84 Cycle Introduction

G84 cycle is used in CNC turning machines for tapping holes from the front to the workpiece. In this tapping cycle, when the bottom of the hole has been reached, the spindle is rotated in the reverse direction. It is the same as the G88 cycle as a command format, the only difference is that it is used for tapping holes in the Z axis direction, not in the X axis direction.

After the command is used, tapping to the other coordinates is continued by positioning the X axis or C axis. The G84 cycle continues to run until the G80 command arrives.

G84 Cycle Format

G84 Z(W)_ R_ P_ F_ Q_ K_ M_ ;

Parameters

G84: Tapping cycle
Z_ or W_ : Final drilling depth (Z for absolute, W for incremental)
R_ : The distance from the initial level to point R level
P_ : Dwell time at the bottom of a hole
Q_ : Depth of cut for each cutting feed (For Fanuc controller; Bit 6 (PCT) of parameter No. 5104 = “1”)
F_ : Cutting feedrate
K_ : Number of repeats (When it is needed.)
M_ : M code for C-axis clamp (when it is needed.)

Peck Tapping

When you use Q in cycle line, it’s automatically switch to Peck tapping cycle. If depth of cut (Q) is not specified for each tapping, the normal tapping cycle is used. Same format can be use for G88 cycle also to drill from X axis side.

G84 Cycle Examples

G84 CNC Program Example – 1

O1234; Program no
M51 ; Setting C-axis index mode ON
M3 S2000 ; Rotating the tap
G00 X50.0 C0.0 ; Positioning the tapping along the X- and C- axes
G84 Z-40.0 R-5.0 P500 F5.0 M31 ; Tapping hole 1
C90.0 M31 ; Tapping hole 2
C180.0 M31 ; Tapping hole 3
C270.0 M31 ; Tapping hole 4
G80 M05 ; Canceling the tapping cycle and stopping tap rotation
M50 ; Setting C-axis index mode off
M30 ; Program end
Note:
M31 : C axis Clamp


Need to more?

In this article, we described How to use G84 cycle for front tapping in CNC lathe machines with all details and examples. For more details;

For your comments, suggestions and questions, you can write to us from the “Comments Section” below without registration and please consider to share this post!

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.
...