Question

Does anybody have experience using the Y axis for parting? I want to try it but need to use G96 constant surface speed using the Y axis in place of the X axis. I’m assuming there should be a parameter I can change somewhere? The machine is a Tsugami M08SY with a Fanuc OI-TF. Thank you.

Comments

Prevent Upset Stomach While Using Cephalexin  http://cialibuy.com - where to buy cialis online safely Does Amoxicillin Have Penicillin In It  <a href=http://cialibuy.com>Buy Cialis</a> Nonprescription Orlistat

---

Kamagra Best Place To Buy  http://abcialisnews.com - cialis generic Where To Purchase Stendra Avanafil  <a href=http://abcialisnews.com>cialis 5mg</a> Acquisto Levitra Italiano

Answer 1

for this machine I do not know but for an Integrex I200S for X axis is G96S300P1 and for Y axis is G96S300P2

Good luck!